Table of Contents
Advertisement
The torque setting required to drive
LED light
screws will differ with different
materials. Start with the torque setting
on the number you think is appropriate
(Eg: 4) and simply increase the torque
adjustment collar to a higher number if
the screw head is not sitting flush with
your work piece. Remove the screw
after adjusting and re-drive the screw
back into the work piece until the
correct torque adjustment leaves the
screw head flush with your work piece.
LED LIGHT
› The drill has one LED Light built into
the unit (Fig. 8).
Fig.8
› The LED light turns on automatically
when you press the on / off trigger.
› The LED light illuminates dark areas
in tight corners to assist with drilling
and screw driving. This helps achieve
a more accurate result in your work
piece.
DRILLING IN ALL MATERIALS
› Always use sharp drill bits.
› Mark the place where you would like
the hole to be drilled.
› Commence with a slow speed to start
the hole (see section "Speed Control"
for directions on how to do this).
› Reduce your pressure on the drill
when the drill bit is about to break
through the material.
15
Advertisement
Table of Contents
