Table of Contents
Advertisement
INSTALLING AND REMOVING
THE BATTERY
Always switch off the drill before
insertion or removal of the battery.
INSTALLING THE BATTERY
1. Hold the drill upright and pick up the
battery in your opposite hand. Place two
fingers over the battery release buttons
and insert the battery until it clicks into
place (Fig. 1).
2. Do not use excessive force when
inserting the battery. If the battery does
not slide in easily, it is not being inserted
Fig.1
correctly. It is also possible that there
could be damage to the battery, battery
terminals or the drill.
REMOVING THE BATTERY
Press both the battery release buttons on
either side and gently pull the battery out
of the drill.
BATTERY LIFE
The length of service from each charging
cycle will depend on the type of work you
are doing. To obtain the longest possible
battery life, we suggest the following:
› Store and charge your battery in a cool
area. Temperatures above or below normal
room temperature will shorten battery life.
› Never store batteries in an uncharged
condition. Recharge them immediately
after they are uncharged.
10
Advertisement
Table of Contents
