DISASSEMBLY- AND RE-ASSEMBLY ADVICE
F. Thermostat removal
1. Follow previous step A
2. Remove the 3 screws
G
G
3. Follow previous step B, C, D
By step C do not cut the wires.
Note: be careful with the wire / heating element
connecting, this connection is fragile.
4. Remove the thermostat sensor by undoing the metal band.
Note: Please make sure while re-assembling the new
thermostat that the routing will be done as
shown in below picture.
from the thermostat assy.
G
G
metal band
HD9220/40 /42 /44
G. Motor assy removal
1. Follow previous step A, B, C, D
By step C do not cut the wires.
2. Remove the thermostat sensor (See instruction F 4)
3. Remove the fuse and the earth connection from the
double heat shield.
Fuse
Earth connection
4. Cut the motor wires half way and remove the motor fan
assy.
Double
heat shield
6-9