Drain Hose Installation Instruction; Bottom Cover Installation Instruction - Panasonic NA-F70HR2 Operating Instructions Manual

Drain Hose Installation Instruction

1. Lay down the washing machine with the back
body facing to the upside.
Drain Hose
Spread a mat such as cardboard under the body to avoid scratches.
To change the drain hose to opposite.
1. Lay down the washing machine with the back
body facing to the upside.
2. Remove the screw fixing the hose holder.
3. Remove the hose holder from the base.
Caution
Make sure the hose holder is fixed on the base properly
to avoid water leaking caused of the hose damaged.
Note
Make sure to remount the bottom cover after pulling out
the drain hose or changing its position.

Bottom Cover Installation Instruction

A. Purpose
For safety precaution.
B. How to install Bottom Cover to the Base
1. Lay down the washing machine with the back
body facing to the upside.
2. Adjust the Hose Hole Cover A (accessory) to the
slot at the base.
3. Fix Bottom Cover (accessory) where surface with
UP indication is facing to the washing machine.
And slide down the bottom tip of the Bottom
Hose Hole Cover A
20
NA-F70HR2_EN.indd 20
Rear
Tape
Front
Hose Holder
Screw
(The drain hose is installed inside the bottom of the base.)
2. Peel off the tape and pull out the drain hose
from the base.
Base
Drain Hose
(Ex. Changing hose position from right to left.)
4. Move the hose holder to opposite side.
Then insert the hose holder to left hose outlet
position of the base.
Note
Do not remove the hose
holder from the drain hose.
5. Fix the hose holder with screw properly.
Note
Make sure the drain hose
is not twisted.
Cover (about 1/3 from the bottom) and slightly
bend the upper part toward you so that the
convex part on both sides don't touch the back
of the body. Then slide it down completely.
4. Securely fasten the 2 screws of the Bottom
Cover to the Base.
Convex Part
Pull out.
Bottom Cover
Base
2/28/12 1:26:52 PM