Table of Contents
Advertisement
Maintenance
To prevent from fungus growth at the outer tub area.
"Tub Dry"
3
Remark: Please be informed do not put laundry inside the tub during this program.
1
Press the [Power On/Off] button.
Press the [Program] button 5 times
2
for selecting "Tub Hygiene" Course.
3
Press the [Process] button once for selecting only "Spin".
4
Press the [Start/Pause] button.
The buzzer lets you know when the washing is finished.
Maintenance
Water supply hose filter / Ag Air-Filter / Lint filter / Main unit and tub
Water supply hose filter
•
When water supply seems constricted.
•
Be absolutely sure to follow
the procedures as described,
otherwise water will spray out.
1
Ag Air-Filter
✻
Do not wash
with water.
Lint filter
(Lint filter A)
1
Remove the lint filter A.
(Lint filter B)
1
Pull out the lint filter B
from the lock.
By using fingers to
press and pull out at
the upper part of the lint filter's side.
•
When the filter is torn, etc., obtain another one from the place of purchase.
•
Turn the wash tub if the filter cannot be removed easily.
Main unit and tub
Main unit
•
Wipe with a soft cloth. Use a neutral dishwashing liquid or soap for stubborn
places.
✻
Do not apply water directly.
✻
Do not use cleanser, paint benzine, alcohol, kerosene, etc.
✻
Follow any instructions that come with a chemically treated cloth.
16
NA-F70HR2_EN.indd 16
2
Remove the filter cover, then
Remove any kind of dust
pull out the Ag Air-Filter.
from the filter.
•
Remove the accumulated lint regularly. When the filter is full of lint, the filter could
be torn from rubbing with the laundry during washing cycles.
2
Remove the lint
from the filter.
•
The [Tub Hygiene] light will be indicated.
•
Spinning operation will be operated for 30 minutes
1. Turn off the water faucet.
2. Press the [Power On/Off] button.
3. Press the [Start/Pause] button.
The Water Level will light up a few seconds later.
4. Press the [Power On/Off] button to turn off the power.
5. Loosen the nut.
6. Take off the hose.
7. Clean the filter.
3
Set it back to the original position
by pressing the left /right sides of
the filter cover.
✻
Do not press the middle of the
filter cover.
(Lint filter A)
3
Put the filter back in.
Make sure it clicks into
place.
(Lint filter B)
3
Set it back to the
original position.
•
Insert the bottom
first as shown in the figure.
•
Press down and lock as the arrow.
• Upper part of the tub
Wipe with a damp cloth.
✻ Do not apply water directly.
The floor could get wet.
1
4
2
2/28/12 1:26:31 PM
Advertisement
Table of Contents
