Locking Locomotive Into A Direction; Reset To Factory Default; Automatic Sound Effects - M.T.H. premier M10000 Operator's Manual

Locking Locomotive Into A Direction

You can lock your engine into a direction (forward, neutral, or reverse) so that it will not
change directions. To do this, put the engine into the direction you want (or into neutral
to lock it into neutral), run it at a very slow crawl (as slowly as it will move without
halting), and quickly but firmly tap the Horn button once followed by three quick taps of
the Bell button, allowing approximately ½ second to lapse between each quick button
press. Two horn blasts will indicate that the engine has made the change. The engine will
not change direction (including going into neutral) until you repeat the 1 horn, 3 bells
code to return the engine to its normal condition, even if the engine is kept without power
for extended periods of time.
Place
Engine into
Horn
Desired
Direction

Reset To Factory Default

To override the settings you currently have assigned to the engine and reset it to its
factory defaults, while in Neutral tap the Horn button quickly once, followed by five
quick taps of the Bell button, allowing approximately ½ second to lapse between each
quick button press. Two horn blasts will indicate that the engine has made the change.
Place
Horn
Engine in
Neutral

Automatic Sound Effects

Certain Proto-Sound 2.0 sound effects automatically play in programmed conventional
mode conditions:
•
Squealing Brakes play any time the engine's speed decreases rapidly.
•
Cab Chatter plays at random intervals when the engine idles in neutral.
•
Engine Start-up and Shut-down sounds play when the engine is initially powered
on or is powered off for five seconds or more.
Premier M10000 Locomotive Set
Horn Bell
Bell Bell
Bell Bell
Bell Bell
Direction Lock
Two Horn Blasts
=
(indicates change is made)
Repeat to Return
to Normal Condition
Two Horn Blasts
=
Bell
(indicates change is made)
Repeat to Return
to Normal Condition
Reset
11