Operations; Watching A Tv Programme; [Sleep Timer]; Freeze Mode - FUNAI 100FD714 Instruction Manual

OPERATIONS

Read this first
These operations are accessible by remote control.
Some may also be accessible by controls on the main
unit.

Watching a TV Programme

To select a channel
Use repeatedly to select your desired
channel, or use the Number buttons to enter a
specific channel number, then press OK for quicker
access.
(e.g.) If you want to select the channel 24 without
pressing OK, press 2 first, then press 4 within 3
seconds.
To adjust the volume
Use to increase / decrease the audio
volume.
Press to turn the sound on / off temporarily.
• You can recover the original volume by pressing
or .

[Sleep Timer]

The sleep timer can be set for the unit to go to the
standby mode after an incremental period of time.
1
Press SLEEP repeatedly to change the sleep
time period.
• Each time you press SLEEP, the timer increases from
10 minutes up to 240 minutes.
• Press SLEEP repeatedly until [Off] appears to cancel the
sleep timer.
• If the unit goes into standby mode, the sleep timer will be
cancelled.

Freeze Mode

Freeze Mode can freeze the image shown on the TV
screen for 5 minutes.
1
Press FREEZE to freeze the image.
• The sound output will not be paused.
• To cancel freeze mode, press any buttons except

Teletext

1
Press
display Teletext information.
2
Press
transparent mode or picture and teletext mode.
• If you want to select other pages, use the Number buttons
or ▲ / ▼.
• To enlarge fonts, press
• To select the teletext subpages, press
• To directly select the page numbers shown at the bottom of
the TV screen, use RED / GREEN / YELLOW / BLUE.
• To call up the hidden information, press
• To hold the current page, press
• To go back to the start page, press
3
Press EXIT to exit.

Favourite

You can easily locate a favourite channel.
• You can set favourite channel at "[Programme Edit]" (p. 18).
1
Press FAV while watching a programme to show
again
the favourite channel list.
2
Use ▲ / ▼ to select the channel you want, then
press OK.
• Use
• This unit need few seconds to memorise the favourite
setting.
• If you unplug the AC power cord immediately after the
setting, it will not be registered in the memory.
3
Press EXIT to exit.
.
to turn on the teletext decoder and
repeatedly to show the teletext in
.
.
Favorite List
1 TF1 HD ATV
2 FR 2 HD ATV
6 M6HD ATV
ENTER
to move to the previous or next page.
.
.
.
11