Barco Nio 3MP User Manual page 15

W
ARNING
dard).
Use an arm that can support the weight of the display. Refer to the technical specifica-
tions of this display for the applicable weight.
Overview
The panel, standard attached to the tilt & swivel foot, is compatible with the VESA 100 mm standard. So
it can be used with an arm stand according to the VESA 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the panel.
1. Put the display in the lowest position and fasten the height mechanism, see "Unlocking the height
mechanism", page 9 .
2. Put the display face down on a clean and soft surface. Be careful not to damage the panel screen.
3. Remove the plastic cover with a flathead screw driver.
4. Slide the plastic cover over the neck of the foot.
K5902067 NIO 3MP LED DISPLAY 26/11/2014
:
Use an arm that is approved by VESA (according to the VESA 100 mm stan-
3. Display installation
13