Baxi 100/2 HE Plus Installation & Servicing Instructions Manual page 12

230V
50Hz
L N E
g/y
Room
Timer
L
N
CH on
HW on
HW off
Y Plan, Room Thermostat System, CH Interlocked By Room Thermostat
At least the Radiator(s) near the Room Thermostat not TRV'd
Pump run from Switched Live
By-pass permitted but not required for Part L1 compliance
230V
gr
50Hz
L N E
b
br
g/y
Room
Timer
L
N
CH on
HW on
S Plan, Room Thermostat System, CH Interlocked By Room Thermostat
At least the Radiator(s) near the Room Thermostat not TRV'd
Pump run from Switched Live
By-pass permitted but not required for Part L1 compliance
230V
50Hz
L N E
g/y
Timer
L
N
CH on
HW on
HW off
Y Plan, Fully TRV'd System, CH Interlocked By Boiler Flow Switch
Room Thermostat should not be fitted
Pump must be run from Boiler P/F connection for Part L1 compliance
By-pass not permitted (must be valved off) for Part L1 compliance
12
Y Plan
b
Diverter
w
Valve
Cylinder
gr
Stat
1
o
Stat
C 2
Boiler
L E
Pump
N E L
gr
b
Motor Motor
br
S Plan S Plan
o
g/y
Valve Valve
Cylinder
o
Stat
Stat
Boiler
L E
Pump
N E L
Y Plan
b
Diverter
w
Valve
Cylinder
gr
Stat
1
o
C 2
Boiler
L E
Pump
N E L
Key to colours
b - Blue
br - Brown
w - White
o - Orange
gr - Grey
g/y - Green/Yellow
This boiler does not require a bypass.
This boiler does not require a permanent live.
N P/F
The pump only needs wiring directly to the boiler for
fully TRV'd systems.
1. To comply with Part L1 of the Building Regulations the
heating system into which the boiler is installed should
include the following:
2. Such a system needs to be fully pumped and must
provide independent temperature and time control to
both the heating and hot water circuits and have a boiler
interlock.
3. The boiler should be controlled so that it operates on
demand only. Where it is proposed to effect control by
thermostatic radiator valves, a room thermostat (or
other device such as a flow switch - a flow switch is
integral to this boiler) should also be provided to switch
off the boiler when there is no demand for heating or hot
water.
N P/F
4. The interlock for the CH circuit can be provided by
either a Room Thermostat or a fully TRV'd system with
the pump wired back to the boiler without a bypass.
Connection diagrams for both options for Y and S plan
systems are shown.
50Hz
L N E
N P/F
Timer
CH on
HW on
S Plan, Fully TRV'd System, CH Interlocked By Boiler Flow Switch
Room Thermostat should not be fitted
Pump must be run from Boiler P/F connection for Part L1 compliance
By-pass not permitted (must be valved off) for Part L1 compliance
6.0 System Details
6.6 System Controls
a) zone controls
b) timing controls
c) boiler control interlocks
230V
gr
Motor
b
S Plan
Valve
g/y
Cylinder
br
Stat
L
N
N E
gr
b
Motor
br
S Plan
o
g/y
Valve
o
Boiler
L E N P/F
Pump
L