Cisco DPC3939 User Manual page 53

Use the descriptions and instructions in the following table to manually configure
the basic settings for wireless communication for the Residential Gateway. After you
make your selections, click Save Settings to apply your changes or Restore Default
Settings to set values back to factory default values.
Field Label
Wireless Network
Network Name for 5
GHz (SSID 2)
Mode
Security Mode
OL-29 163 -01
Description
Use this setting to Enable or Disable the wireless network.
The SSID is the name of your wireless network. The SSID is
used by wireless technology to identify your network from
other wireless networks in the area. The SSID can be up to 32
characters long.
The factory-set SSID is HOME-XXXX-5 where XXXX is the last
4 digits of the cable modem MAC address, which is found on
the label located on the bottom of the Residential Gateway.
The factory-set SSID is a unique identity and does not need to
be changed unless you choose to do so.
Choose one of these options for the network mode:
 802.11 a/n

801.11 n
Important: The following Security mode is recommended:
WPAWPA2-PSK (TKIP/AES).
Choose one of these options for the security mode.
 Open (risky)

WEP 64 bits (5 Ascii characters or 10 Hex digits)

WEP 128 bits (13 Ascii characters or 26 Hex digits)
 WPA-PSK(TKIP) (8 to 63 Ascii characters or 64 Hex digits)

WPA-PSK(AES) (8 to 63 Ascii characters or 64 Hex digits)
 WPA2-PSK(TKIP) (8 to 63 Ascii characters or 64 Hex digits)

WPA2-PSK(AES) (8 to 63 Ascii characters or 64 Hex digits)
 WPA2-PSK(TKIP/A ES) (8 to 63 Ascii characters or 64 Hex
digits)
 WPAWPA2-PSK(TKIP/A ES) recommended (8 to 63 Ascii
characters or 64 Hex digits)
Note: Not all wireless adapters support WPA2. WPA is
supported across a wider range of devices. Whether you use
WPA or WPA2, make sure to use a strong passphrase. A strong
passphrase is a string of random characters at least 21
characters in length.
Configure Wireless Settings
31