Jumper Cable Use; Moving Machine By Hand - Husqvarna Z 242F Operator's Manual

Weak Battery
If the battery is too weak to start the engine, it should be
recharged. (See Battery in the Maintenance section.)
If jumper cables are used for emergency starting, follow this
procedure:

Jumper Cable Use

1. Connect each end of the RED cable to the POSITIVE (+)
terminal on each battery, taking care not to short against
chassis.
2. Connect one end of the BLACK cable to the NEGATIVE (-)
terminal of the fully charged battery.
3. Connect the other end of the BLACK cable to a good
CHASSIS GROUND on the mower with the discharged
battery, away from the fuel tank and battery.
To remove cables, reverse order
1. Remove BLACK cable first from chassis and then from the
fully charged battery.
2. Remove RED cable last from both batteries.
CAUTION! Lead-acid batteries generate explosive
gases. Keep sparks, flame and smoking materials away
from batteries. Always wear eye protection when around
batteries.
IMPORTANT INFORMATION The mower is equipped
with a 12-volt negative grounded system. The other vehicle
must also be a 12-volt negative grounded system. Do not
use your mower to start other vehicles.
OPERATION

Moving Machine By Hand

When pushing or pulling the mower, engage the EZT bypass
linkages. The EZT bypass linkages are located on the rear of
the frame, below the rear engine guard.
1. Raise the deck into the highest cutting position.
2. Move the steering / park brake controls inwards to the
neutral position.
3. Pull the EZT bypass linkages up and out of the keyhole
slots. Release the levers with the head outside the frame
and held in the bypass position.
4. To reengage the EZT's to drive, reverse the above
procedure.
Load the machine into truck or trailer by driving slowly up the
ramps. DO NOT LIFT! The machine is not intended to be lifted
by hand.
WARNING! Bypass linkages are located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levers are
handled.
WARNING! Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the park brake activated
WARNING! Use extreme caution when loading the
machine into a truck or trailer using ramps. There is the
possibility of serious injury or death if the machine falls off
the ramps.
19
2
1