Dmx 512 Connection; Dmx Channels - Beamz 150.682 Instruction Manual

DISPLAY
1. To the function mode you need, press Enter to confirm, press MODE about two seconds to quit.
Note:
2. The equipment can accept DMX signal whenever Auto or sound active mode, DMX is preferential.
3. Black out mode: Choose Yes, when no DMX, the unit goes to be Black out mode; Choose No, when no DMX, the
unit goes to be Sound mode.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are
connected. If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.

DMX CHANNELS

1 Channel Mode
8
Display Mode
DMX address setting
ADDR
Channel mode
CHND
Slave mode
SLND
Sound mode
SOUN
Sound sense
SENE
White Balance
BALA
Black out mode
BLND
LED mode
Led
Display inversion
DISP
Test mode
TEST
Temperature
TEMP
Using time of light
Hour
Channel Value
000-007
008-022
023-037
038-052
053-067
068-082
083-097
1
098-112
113-127
128-142
143-157
158-172
173-187
188-202
203-217
Function
A001-A512
1CH/3CH/5CH/7CH/15CH/18CH
Master
Slave 1 Slave 2
Sound on/off
Sound sense 0-100
Red 050~255
Green 050~255
Blue 050~255
LED mode, YES – NO
ON (led display on)
Display Inversion,Idsp-dspI
Self test
0 ~ 9999
Fixture hours,0 ~ 9999
Description
Blackout
Show 1
Show 2
Show 3
Show 4
Show 5
Show 6
Show 7
Show 8
Show 9
Show 10
Show 11
Show 12
Show 13
Show 14