Assembly Instructions - Uniflame NBC1218G Owner's Manual

Assembly Instructions

DO NOT RETURN PRODUCT TO STORE.
For assistance call 1.800.762.1142 toll free . Please have your owner's manual and serial
number available for reference .
For Easiest Assembly:
• To avoid losing any small components or hardware, assemble your product on a hard level
surface that does not have cracks or openings .
• Clear an area large enough to layout all components and hardware .
• When applicable, tighten all hardware connections by hand first . Once the step is
completed, go back and fully tighten all hardware .
• Follow all steps in order to properly assemble your product .
Step
Attach lid handle and top hinges
1
A . Attach lid handle to lid using 2 sets of heat resistant washers (H), large washers
(G), large lock washers (J) and large wing nuts (E) .
B . Attach top hinges to lid using 2 sets of small screws (B), heat resistant washers
(H), small washers (F), small lock washers (I) and small wing nuts (D) .
Step
Attach bottom hinges
2
Attach bottom hinges to bottom bowl using 4 sets of small screws (B), heat
resistant washers (H), small washers (F), small lock washers (I) and small wing
nuts (D) .
Step
Attach side handles
3
A . Attach left side handle to bottom bowl using 2 sets of large washers (G), large
lock washers (J), and large wing nuts (E) .
B . Attach right side handle with ignitor to bottom bowl using 2 sets of large washers
(G), large lock washers (J), and large wing nuts (E) .
Outdoor LP Gas Barbecue Grill Model No. NBC1218G
Step
Attach legs
4
Attach the legs to the bottom bowl using 4 sets of special screws (C), large washers
(G), large lock washers (J) and large wing nuts (E) .
Note: Make sure rings on legs face front of grill .
Step
Attach heat shield, burner, regulator and ignitor wire
5
A . Attach heat shield and burner using wing bolt (A) .
B . Pull ignitor wire through opening below regulator .
C . Screw regulator clockwise onto burner stem .
D . Insert ignition wire in bottom of ignitor .
WARNING: To avoid electrical shock, inspect before each use to make
sure the igniter and wire are fully connected.