Bridge-Mono 16/8 Mode; Bridge-Mono 100V Mode - Crown CTS4200 Operation Manual

2 Setup
(continued)

2.9.3 Bridge-Mono 16/8 Mode

CAUTION: Never change the position of
the Mode Switch while the amplifi er
power is on.
Typical analog input and output wiring, along
with level control and Mode Switch settings are
shown in Figure 2.11. Make sure the Mode
switch is set to the "Bridge 16/8" position.
INPUTS: Connect input wiring only to the lower-
(odd-) numbered channel pair.
OUTPUTS: Connect the speaker across the
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
NOTE: When operating the channel pair in
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.

2.9.4 Bridge-Mono 100V Mode

CAUTION: Never change the position of
the Mode Switch while the amplifi er
power is on.
Typical analog input and output wiring, along
with level control and Mode Switch settings are
shown in Figure 2.12. Make sure the Mode
switch is set to the "Bridge 100V" position.
INPUTS: Connect input wiring only to the lower-
(odd-) numbered channel pair.
OUTPUTS: Connect the speaker across the
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
NOTE: When operating the channel pair in
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.
page 12
BRIDGE
DUAL DUAL
CH 2 CH 1
CH 4 CH 3
DUAL DUAL
BRIDGE
Figure 2.11 System Wiring and Control Settings, Bridge-Mono Mode, 16/8 Ohm.
100V
BRIDGE
DUAL DUAL
CH 2 CH 1
CH 4 CH 3
DUAL DUAL
BRIDGE
Figure 2.12 System Wiring and Control Settings, Bridge-Mono Mode, 100V
CTs Multi-Channel Power Amplifi ers
See the
Crown
Amplifi er
Appli cation
Guide,
Operation Manual