Choose Input Wire And Connectors; Choose Output Wire And Connectors - Crown CTS4200 Operation Manual

2 Setup
(continued)

2.7 Choose Input Wire and Connectors

If you will be connecting an analog audio signal to the CTs amplifi er, please
read this section. Figure 2.6 shows connector pin assignments for balanced
wiring, and Figure 2.7 shows connector pin assignments for unbalanced
wir ing.
When possible, use balanced wiring for signal input, which provides better
rejection of unwanted noise and hum. For more information, refer to the Crown
Amplifi er Application Guide, available online at www.crownaudio.com
NOTE: Custom wiring should only be performed by qualifi ed
per sonnel.

2.8 Choose Output Wire and Connectors

Crown recommends using professionally constructed, high-quality, two- or
four-conductor, heavy gauge speaker wire and connectors. You may use
ter minal spade lugs or bare wire for your output connectors (see Figure 2.8).
CTs amplifi er terminal strips accept up to 10 AWG terminal forks which fi t over
a #8 screw. For best results, Crown recommends Panduit part #PV10-10LF-L
or equivalent terminal spade lug. Screw spacing is shown in Figure 2.8.
To connect outputs, fi rst remove the touch-proof cover plate covering the
ter minal strip by removing the screw which holds it in place.
To prevent the possibility of short-circuits, wrap or otherwise insulate exposed
loudspeaker cable and connectors. Also, a touch-proof cover plate, which
covers the terminal strips, is provided to help prevent short circuits. The cover
plate should be reinstalled after connecting outputs.
Suggested below are guidelines to select the appropriate size of wire based on
the distance from amplifi er to speaker. Check with local code as this may vary.
CAUTION: Never connect the speaker return to the chassis of the
amplifi er, or damage to the amplifi er may result.
CAUTION: Never use shielded cable for output wiring.
page 10
Distance Wire Size
up to 25 ft. (7.6 m) 16 AWG
26-40 ft. (7.9-12.2 m) 14 AWG
41-60 ft. (12.5-18.3 m) 12 AWG
Over 60 ft. (18.3 m) 10 AWG
NOTE: CTs 8200 USP/CN is shown. Some CTs 4200 USP/CN features are in different locations.
Figure 2.8 Output Connector Wiring
(Typical of Two C hannels)
CTs Multi-Channel Power Amplifi ers
Figure 2.6 Balanced Input
Connector Wiring
See the Crown Amplifi er
Appli cation Guide, available
online at www.crownaudio.com,
for pin assignments for
Figure 2.7 Unbalanced Input
Connector Wiring
Output panel
shown with
touch-proof
cover plate
removed.
Operation Manual