Fujitsu Primergy RX100 S4 Start Manual page 6

8
Turning off the power and installing optional devices
Install optional devices to be installed after the OS installation, such as UPS device.
������������ "Chapter 7 Installing Internal Options"
1
Check that no medium is inserted in
the floppy disk drive or CD-ROM drive.
2
Exit the operating system (OS).
After the OS is exited, the server is automatically
turned off. When the power of the server is not off
after the OS is exited, press the power switch on the
front of the server.
3
Turn off the power supply of the pe-
ripheral devices, such as the display.
4
Install the optional devices.
9
Hints for error handling
In preparation of a failure occurring, set the fol-
lowing:
������������ "Chapter 5 Operations after OS
Installation"
- Set to collect memory dump
If the memory dump is set, debugging information is au-
tomatically saved when the STOP error occurs in the sys-
tem.
This helps to analyze the cause of error occurrence.
- Create a system restoration disk
When the system file or system environments are dam-
aged, the system can be reconstructed with the content
saved in the system restoration disk.
- Store system settings
By storing the BIOS setting information, the original in-
formation can be recovered with the stored information in
case that the setting information is lost. The stored infor-
mation is also used for the system maintenance.
When the settings are completed, make sure to
check notes before operation.
������������ "5.5 Notes before Operating the
Server"
For details about maintenance after operations have
started, refer to "User's Guide Chapter 9 Operating and
Maintenance".
- After optional devices are installed, set the BIOS Setup
Utility as required.
For details about setting procedures, refer to the "User's
Guide Chapter 8 Configuring Hardware and Utilities".
- If a UPS is installed, set the BIOS Setup Utility as re-
quired. For setup procedures, refer to "User's Guide
5.5.4 Notes on Advanced Uninterruptible Power Supply
(UPS)".
When turning on the server again after turning it off, wait for
at least ten seconds and then press the power switch.
If the server is turned on straight after being turned off, an
error will occur that may cause damage.
10
Support and Service
PRIMERGY information
l
The latest PRIMERGY, update module, driver, and soft-
ware information is available at the address below. Use as
necessary.
http://primergy.fujitsu.com
Before requesting repairs
l
If an error occurs in this server, refer to "User's Guide 9.2
Troubleshooting".
If problems can still not be solved, contact an office listed
in the "Contact Information".
When contacting the office listed in the "Contact Informa-
tion", inform them of the product ID and manufacture num-
ber displayed on the label attached, as shown in the figure
below.
Also read the points to note about requesting repairs be-
forehand in "User's Guide 9.8.2 Contacting Maintenance
Support". Print the "Configuration Sheets"- "Accident
sheet" that is available from Fujitsu PRIMERGY website
(http://primergy.fujitsu.com) and enter the confirmed infor-
mation.
Be careful not to lose this sheet, as you must provide this
information when you contact an office listed in the "Con-
tact Information".
6
����������
������������
������