Cisco UCS C24 M3 Manual page 15

Table 5 Available Plug-In Card RAID Options (continued)
Product ID (PID)
RAID Configuration Options
R2XX-RAID0
R2XX-RAID1
R2XX-RAID5
R2XX-RAID6
R2XX-RAID10
Approved Configurations
For 24-drive backplane with expander systems
■
—
Caveats
There are two full-height PCIe slots available on riser 1 and three half-height PCIe slots
■
available on riser 2.
Cisco UCS C24 M3 High-Density SFF Rack-Mount Server
PID Description
Factory preconfigured RAID striping option
Enable RAID 0 Setting. Requires a minimum of one hard drive.
Factory preconfigured RAID mirroring option
Enable RAID 1 Setting. Requires exactly two drives with the same size, speed,
capacity.
Factory preconfigured RAID option
Enable RAID 5 Setting. Requires a minimum of three drives of the same size,
speed, capacity.
Factory preconfigured RAID option
Enable RAID 6 Setting. Requires a minimum of four drives of the same size,
speed, capacity.
Factory preconfigured RAID option
Enable RAID 10 Setting. Requires an even number of drives (minimum of four
drives) of the same size, speed, capacity.
NOTE: Although RAID levels 50 and 60 are not orderable from the factory, they are
supported for selected controllers as shown in
NOTE: No RAID factory preconfigured RAID option can be chosen (a factory RAID
volume cannot be configured) if:
there are no drives, or
■
SAS and SATA drives are mixed, or
■
different capacity drives are mixed
■
Select one of the following plug-in PCIe RAID controllers from
• LSI MegaRAID 9265CV-8i (supports up to 24 drives)
• LSI MegaRAID 9240-8i or LSI MegaRAID 9220-8i controller (support up to 16 drives)
CONFIGURING the SERVER
Table 5.
Table 5.
15