Casio IT-9000WM Series Quick Start Manual page 33

3. On the IT-9000, in Control Panel, choose the PC Connection option. Confirm that PC
Connection is set to "USB Default". If not, choose 'USB Default' and tap OK button.
Figure 5.18
4. When the IT-9000 is mounted on the USB Cradle, a menu to prompt to install the driver is
displayed. Follow the same steps in Chapter 5.2.1.
Figure 5.19
After driver installation is completed,
- Check "Allow USB connections" in ActiveSync. (See Figure 5.17)
- Dismount the device from the cradle and mount the device on the cradle again.
Caution
- When you turn the USB interface switch on/off, be sure to remove IT-9000 from the Cradle.
- Make sure not to short the feeding terminals. Shorting circuit of the terminals may cause the
defect.
- Don't give any vibration or mechanical shock to the USB interface during communication. If
you do so, it may cause communication malfunction.
- When you set the IT-9000 on the Cradle, be sure to securely set it to the fixing hooks on the
cradle and check the power indicator LED on the front of the cradle lights on. Improper setting
may cause malfunction of communication and/or may not charge the battery.
33