Table of Contents
Advertisement
Electrical work
How to connect your extended power cables
f Items to prepare
f
Tools
Spec
Shape
1. As shown in the figure, peel off the shields from the rubber/wire of the power
cable.
- Peel off 20mm of the wire shields of the tube installed already.
2. Insert both sides of core wire of the power cable into the connection sleeve.
f Method 1
f
Push the core wire in to the sleeve from both sides.
• After peeling off the tube wire, you must insert a contraction tube.
CAUTION
f Method 2
f
Twist the wire cores together and push it in to the sleeve.
3. Using a compressor, compress the two points and flip it over and compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
4. Wrap it with the insulation tape twice and position your contraction tube in the middle of the insulation tape.
f Method 1
f
Insulation tape
40mm
48
칠레향 FAC MEMORY 냉난방_IBIM_EN_03892A(5).indd 48
Crimping plier
Connection sleeve (mm)
MH-14
20xØ6.5(HxOD)
f Method 1
f
Comp. dim.
Compress it 4 times
f Method 2
f
Insulation tape
Width 19mm
Power cable(provided by us)
Power cable (provided by us)
Connection sleeve
f Method 2
f
5mm
Insulation tape
35mm
Contraction tube (mm)
70xØ8.0(LxOD)
(Unit: mm)
20
20
20
60
120
180
20
Connection sleeve
Compress it 4 times
5mm
2014-03-12 오전 9:33:17
Advertisement
Table of Contents
