Table of Contents
Advertisement
4.4.2 Drive program and communication setup
4.4.2.1 Specific drive program must be set up for interfaces of PC and CA210, please refer to
detailed procedures as below:
a) Power on CA210, a dialog box shown as Fig. 3 will display for the first installation after data line
is connected normally;
b) Select option "Install from list or specific location (Advanced) (S).", then press key "Next
step", a dialog box shown as Fig. 4 will display;
USB to RS232
Specific USB to Mini
CA210
Optical
Probe
Fig. 2 System block diagram
VG848
RS232
Test Signal
Fig. 3 Dialog box
Advertisement
Table of Contents
