Sharp Aquos LC-40M500X Operation Manual page 18

Option menu (Continued)
H Digital audio output
This function allows you to select your favourite
audio output system.
Selected item
Dolby Digital Dolby Digital audio will be output when
there is a Dolby Digital audio signal. The
output will be in PCM when there is no
Dolby Digital audio signal.
PCM The optical output format is normally in
PCM.
H Audio only
When listening to music from a music programme,
you can set the display off and enjoy audio only.
Selected item
On Audio is output without screen image.
Off Both screen images and audio are output.
NOTE
• When you make operations that change the picture on the
TV such as by changing the input source, the Audio only
function is set to "Off".
H Game play time
This function displays the elapsed game time so you
do not lose track of the time.
To display the elapsed time, select "GAME" under "AV
mode" for the input mode of the terminal connected
to the game console before starting the game.
Selected item
On The elapsed time is displayed every
30 minutes when you switch to GAME
mode in external input mode.
Off Hides the time.
H Colour system
You can change the colour system to one that is
compatible with the image on the screen. (Auto,
PAL, SECAM, NTSC 3.58, NTSC 4.43, PAL-60)
NOTE
• If "Auto" is selected, colour system for each channel is
automatically set. If an image does not display clearly,
select another colour system (e.g. PAL).
• "Colour system" is selectable only when inputting an
S-VIDEO or composite signal.
H Fine sync. (PC input mode only)
Adjusting the PC image automatically
Auto sync.
This function enables the screen to be automatically
adjusted to its best possible condition when the
analogue terminals of the TV and PC are connected
with a commercially available RGB cable, etc.
16
Description
Description
Description
NOTE
• Auto sync. is likely to succeed when an input PC image
has wide vertical stripes (e.g. pattern with high contrast
stripes, or cross-hatched).
It may fail when an input PC image is solid (low contrast).
Adjusting the PC image manually
Ordinarily you can easily adjust the picture as
necessary to change image position using Auto
sync. In some cases, however, manual adjustment is
needed to optimise the image.
Selected item
Centres the image by moving it to the left
H-Position
or right.
Centres the image by moving it up or
V-Position
down.
Adjusts when the image fl ickers with
Clock
vertical stripes.
Adjusts when characters have low
Phase
contrast or when the image fl ickers.
NOTE
• For resetting all adjustment items to the factory preset
values, press a / b to select "Reset", press ENTER, press
c / d to select "Yes", and then press ENTER.
• Images may not be displayed properly depending on the
settings and/or input signals.
Input signal
• Some input signals may have to be registered
manually to display properly.
• The pairs of input signals (resolutions) in the list
below are not distinguishable when received.
In such case, you have to set the correct signal
manually. After setting once, it will display when the
same signal (resolution) is input again.
1280 g 768
H DivX(R) Reg. Code
Please see USB Media Player on page 27.
H Version up
This function is only for service personnel to use for
software updates.
Description
1360 g 768