Auto Installation; Programme Setup - Sharp Aquos LC-40M500X Operation Manual

Checking Signal
information (Continued)
H Checking Signal information
Press a / b to select "Signal information".
Auto search
Manual search
Manual adjust
Signal information
Antenna power
4
Position and align the antenna so that
the maximum possible values for "Signal
strength" and "Signal quality" are obtained.
NOTE
• The values of "Signal strength" and "Signal quality"
indicate when to check the appropriate alignment of the
antenna.

Auto installation

You can run auto installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen
displays.
2 Press c/d to select "Setup".
3 Press a/b to select "Auto installation", and
then press ENTER.
4
If you have already set the password, enter
it here.
• See page 13 for setting a password.
5 Press c/d to select "Yes", and then press
ENTER.
Press a / b / c / d to select "DTV", "ATV" or
6
"ATV + DTV", and then press ENTER.
Press a/b to select the desired sound
system, and then press ENTER.
• Sound system is selectable when the signal
search is set to "ATV" or "ATV + DTV" mode only.
You do not need to do anything during the
auto search. Press MENU to exit.
Channel number
68
Signal strength
100 100
Current Maximum
Signal quality
Current 98 Maximum 98

Programme setup

Digital settings
You can reconfigure DTV services settings
automatically or manually.
1
Press MENU and the MENU screen
displays.
Press c/d to select "Setup".
2
Press a/b to select "Digital Programme
3
Setup", and then press ENTER. If you have
already set the password, enter it here.
• See page 13 for setting a password.
4 Press a/b to select the desired menu item,
and then press ENTER.
Press c/d to select "Yes", and then press
5
ENTER.
H Auto search (Digital)
Use this menu to add new services automatically
after auto installation has been completed.
H Manual search (Digital)
Add new services within a specified frequency band.
• Press c / d to select the frequency and then press ENTER.
H Manual adjust (Digital)
Configure various settings for each service using the
Colour (R, G, B) buttons.
Digital Programme Setup]
1 Press a/b to select desired service.
2
Press the Colour button on the remote
control corresponding with the item you
want to reconfigure.
• Each time the Colour button is pressed, you can
switch the corresponding operation on/off.
Buttons for Manual adjust operation
Remote
Menu
control
items
buttons
Lock R When the service is locked, you must enter
your password whenever you tune to the
service.
CH G Services with "Skip" are passed over when
pressing r /
Skip
unit.
Sort B The item position of services can be sorted.
Description
s in the TV/remote control
9