Gigabyte GA-X99-SOC Force User Manual page 36

B S_
B
19) SUBZ (Temp Sensor Ports)
You can connect a K probe cable (bought separately) to the ports to measure system temperature. You can
see the detected temperature in BIOS setup (refer to Chapter 2, "BIOS Setup," "M.I.T.\PC Health Status,"
for more information).
F
_ 0
20) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the BIOS configuration and reset the CMOS values to factory defaults. To clear
the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds.
_ F
_ 0 F
Hardware Installation
• Always turn off your computer and unplug the power cord from the power outlet before clearing
the CMOS values.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
S
S
Temp Sensor Port 2
Temp Sensor Port 1
Open: Normal
Short: Clear CMOS Values
- 36 -