Gigabyte GA-X99-SOC Force User Manual page 25

OC Trigger switch (TGR):
This switch allows the overclockers to jump between low and extremely high frequencies in an instant. After remaining at a
low frequency during system boot and OS optimization, the overclocker can then engage the Trigger Switch to instantly hit
the target frequency, save their score submission, grab a screen shot, and watch the records tumble.
2
1: Target frequency set in BIOS Setup or other overclocking application.
1
2
2: Safe frequency (using the lowest CPU ratio, which may vary by CPU)
1
Before using the overclocking buttons, make sure to load the optimized defaults in BIOS Setup to return
the BIOS settings to factory defaults.
Onboard Voltage Measurement Module
Use a multimeter to measure the following motherboard voltages. You can employ one of the following two
ways to measure component voltages.
1
1
Method I (Using the included voltage measurement cable):
Method II (Connecting the multimeter directly):
1 2 3
1
1 2 3
1
1 2 3
1
1 2 3
1
1 2 3
1
1 2 3
1
1 2 3
Pin 1 VRIN
1
1 2 3
Pin 1 DIMM_A
1
1 2 3
Pin 1 DIMM_B
1
Pin 1 DDRVTT_A
Pin 1 DDRVTT_B
Pin 1 VPP25_A
Pin 1 VPP25_B
Pin 1 PCHV
Pin 1 RESV
Steps:
Connect the included voltage measurement cable to a voltage mea-
surement header and your multimeter as shown. Please note the
red wire is the positive and must be connected to the pin 1 (Power).
Steps:
Connect the red lead of the multimeter to the pin 1 (Power) of a
voltage measurement point and the black lead to the pin 2 (ground).
- 25 -
Pin No. Definition
1 Power
2 GND
Hardware Installation