Transmitter And Receiver Binding; Control Test - Vaterra Chevrolet Corvette 2014 Owner's Manual

transmItter anD reCeIver bInDInG

BindinG Procedure
1 Make sure the transmitter and vehicle are both powered OFF.
2 Install a bind plug in the receiver battery/bind port. You
do not need to remove any of the other plugs to re-bind.
3 With the bind plug installed, power ON the vehicle.
The receiver LED will flash green.
4 Move the steering wheel and throttle trigger to the failsafe
positions and continue to hold those positions until the
binding process is complete.

Control test

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
forWard
Brake/reVerSe
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
5 Press the bind button on the transmitter while powering on
the transmitter. The green LED on the transmitter will flash
after 4 seconds when the transmitter is in bind mode.
6 Release the bind button after the red LED on the
transmitter flashes. Continue holding the failsafe positions
until the receiver LED is solid. The green LED on the receiver
will glow solid when the transmitter and receiver are bound.
7 Disconnect the battery from the ESC. Remove the bind plug
from the receiver. The receiver will keep the binding to the
transmitter until another binding is done.
Your Spektrum Transmitter comes
prebound to the vehicle.
If you encounter problems, obey
binding instructions and refer to the
transmitter troubleshooting guide for
other instructions. If needed, contact
the appropriate Horizon Product
Support office.
Perform a control test with the vehicle
wheels off the ground. If the wheels
rotate after the vehicle is powered
ON, adjust the "TH. Trim" knob until
they stop. To make the wheels move
forward, pull the trigger. To reverse
them, wait for the wheels to stop,
then push the trigger. When moving
forward, the wheels should maintain
a straight line without any steering
wheel input. If not, adjust the "ST.
Trim" knob so the wheels maintain
a straight line without having to
turn the steering wheel.
EN