Transmitter And Receiver Binding; Control Test; Binding Procedure - Vaterra Kemora 4WD Rallycross 1/14th RTR Owner's Manual

TransmITTer and reCeIVer bIndInG

BindinG Procedure

1 Make sure the transmitter and vehicle are both powered OFF.
2 Install a bind plug in the receiver battery/bind port.
You do not need to remove any of the other plugs to re-bind.
3 With the bind plug installed, power ON the vehicle.
The receiver LED will flash green.
4 With the steering and throttle in the desired preset failsafe
positions (neutral), press and hold the bind button and power
ON the transmitter. The transmitter's red LED will flash after
4 seconds when the transmitter is in bind mode. Release the
bind button once the red LED flashes. Continue holding the
failsafe positions until the binding process is complete.

ConTrol TesT

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
forWard
Brake/reVerSe
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
5 When the receiver binds to the transmitter,
the receiver LED will turn solid.
6 Power OFF the vehicle, then the transmitter.
7 Disconnect the battery from the ESC.
Remove the bind plug from the receiver.
8 Safely store the bind plug in the bind plug
compartment in the transmitter.
9 The receiver will keep the binding to the
transmitter until another binding is done.
Your Spektrum DX2L comes prebound
to the vehicle.
If you encounter problems, obey
binding instructions and refer to the
transmitter troubleshooting guide for
other instructions. If needed, contact
the appropriate Horizon Product
Support office.
Perform a control test with the vehicle
wheels off the ground. If the wheels
rotate after the vehicle is powered
ON, adjust the "TH. Trim" knob until
they stop. To make the wheels move
forward, pull the trigger. To reverse
them, wait for the wheels to stop,
then push the trigger. When moving
forward, the wheels should maintain
a straight line without any steering
wheel input. If not, adjust the "ST.
Trim" knob so the wheels maintain
a straight line without having to
turn the steering wheel.
EN