Dynamite 12T Esc - Vaterra Chevrolet Corvette 2014 Owner's Manual

DynamIte 12t esC

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
MountinG the eSc
1 Mount the ESC in the location
specified by your vehicle's
instruction manual.
Important: Ensure all wiring
connections can be reached
prior to mounting.
2 The ESC can be mounted in vehicles
with mounting posts using the
removable mounting tabs.
3 If the vehicle doesn't have mount-
ing posts, remove the tabs and use
double-sided foam tape to secure
the ESC in position.
4 The switch can be mounted to the
side of the ESC with the slide mount.
Or use double-sided foam tape to
secure the switch in a convenient
location in the vehicle.
connectinG the eSc
1 Connect the RED (+) ESC wire
to the RED (+) motor wire.
2 Connect the BLACK (–) ESC wire
to the BLACK (–) motor wire.
notICe: Always disconnect the
battery from the ESC when you have
finished operating your vehicle. The
ESC's switch only controls power
to the receiver and servos. The ESC
will continue to draw current when
connected to the battery, resulting
in possible damage to the battery
through over-discharge.
caliBratinG the eSc
Ensure proper ESC function by calibrat-
ing the ESC to your transmitter inputs.
Power OFF the ESC.
1
2 Ensure your transmitter is powered
ON, the throttle is not reversed, the
throttle trim is neutral and the throttle
travel range is at 100%. Disable any
special functions such as ABS, etc.
3 Keep the throttle at neutral and
power ON the ESC.
4 The ESC automatically calibrates
the throttle range after 3 seconds.
5 One long beep will sound when
the ESC is ready to run.
SPecificationS
type
Brushed
constant/Peak
40A/180A
resistance
0.002 Ohms
function
Forward/Brake/Reverse;
Forward/Brake
Vehicle type
1/12 on-road; 1/10 on- and off-road;
1/10 rock crawler
operation
Proportional forward, proportional
reverse with braking delay
input Voltage
2-cell Li-Po, 5-9 cell Ni-MH/Ni-Cd
Motor type
540-/550-size closed endbell
motors: 2S Li-Po down to 8T
Bec output
5V/2A
overload Protection
Thermal
dimensions
1.40 in x 1.34 in x 0.71 in
(35.6 x 34 x 18mm)
Weight
1.41 oz (40 g) with wires
Battery connector
EC3 connector
Motor connector
3.5mm Tamiya style bullet
EN