Events; Face Detection - Nexcom NCm-301-V User Manual

Hide thumbs Also See for NCm-301-V:

Table of Contents

Chapter 2: Camera Configuration

Events

You can configure the camera to detect faces and trigger the events enabled

in the Event Actions menu on page 46. The instructions below illustrate

how to setup face detection.

1. Check the Enable Face Detection and on the live video screen below,

select the area for face recognition by holding down the mouse button

and drag to make a rectangular square, release the button once the

desired area is covered.

2. Press the Setting Area button to set this area for face recognition.

To delete the area, press the Remove button.

Threshold

Configures the sensitivity of the face recognition, the range is 1~9, with 1

being the least sensitive.

Detect Direction

Configures the direction to detect faces.

Up:

Detect faces on the top (90 degrees from the front).

Right:

Detect faces on the right (180 degrees from the front).

Left:

Detect faces on the left (-180 degrees from the front).

Down:

Detect faces on the bottom (-90 degrees from the front).

Detection Box

Configures which detection zones are used for face recognition, the options

are Rectangle, ROI and Rectangle + ROI.

Detection Zone

NCm-301 User Manual

Table of Contents

Ncm-301-vm Ncm-301-2v Ncm-301-2vm