Page 1
INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES MODELS MODELO MSV2623 MSV3025 If your pressure washer is not working properly or if there are parts missing or broken, please DO NOT RETURN IT TO THE PLACE OF PURCHASE. Contact our customer service department at www.simpsoncleaning.com.
EASY INSTALLATION WARNING: DO NOT OPERATE ThIs uNIT uNTIl yOu READ ThIs INsTRucTION MANuAl AND ThE ENGINE INsTRucTION MANuAl fOR sAfETy, OPERATION AND MAINTENANcE INsTRucTIONs. INSTALACIÓN FÁCIL AVERTENcIA: NO OPERE EsTE EquIPO hAsTA hAbER lEíDO y ENTENDIDO lAs INsTRuccIONEs DE sEGuRIDAD, OPERAcIóN y MANTENIMIENTO EN EsTE MANuAl DEl OPERADOR y EN El MANuAl DEl PROPIETARIO DEl MOTOR.
Page 3
ATTACh hIGh PRESSuRE hOSE (C) TO GuN (D). TIGhTEN SE CuRELy. CONECTE LA mANGuERA DE ALTA PRESIóN A LA PISTOLA y AjúSTELA fIRmEmENTE. CONNECT ThE hIGh PRESSuRE hOSE (C). CONNECT EL TubO DE ALTO PRESIóN (C). CONNECT ThE GARDEN hOSE (N). CONECTE LA mANGuERA DEL jARDíN.
SAFETY GUIDELINES - DEFINITIONS This manual contains information that is important for you to know and understand. This information relates to protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this information, we use the symbols below. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Page 5
WARNING: This product may not be equipped with a spark-arresting muffler. If the product is not equipped and will be used around flam ma ble ma teri als or on land covered with materials such as agricultural crops, forest, brush, grass or other similar items, then an ap proved spark arrester must be installed and is legally required in the state of California.
Page 6
DANGER: RISk TO bREAThING (ASPhyxIATION) whAT CAN hAPPEN hOw TO PREVENT IT • Breathing ex h aust fumes will cause • Operate pressure washer in a well- se r i o us injury or death! En g ine ventilated area. Avoid en c losed areas exhaust contains carbon mon o x i de, such as ga r ages, base m ents, etc.
Page 7
DANGER: RISk Of INjuRy fROm SPRAy whAT CAN hAPPEN hOw TO PREVENT IT • High-velocity fluid spray can cause • Always wear ANSI-approved Z87.1 objects to break, propelling particles safety glasses. Wear protective clothing at high speed. to protect against accidental spraying. • Never point wand at or spray people or animals.
Page 8
DANGER: RISk Of INjuRy OR PROP ER Ty DAmAGE whEN TRANSPORTING OR STORING whAT CAN hAPPEN hOw TO PREVENT IT • Fuel or oil can leak or spill and could • If pressure washer is equipped with a fuel result in fire or breathing hazard. Se r i- shut-off valve, turn the valve to the OFF ous in j u r y or death can re s ult. Fuel or position before transporting to avoid fuel oil leaks will dam a ge carpet, paint or leaks. If pres s ure wash e r is not equipped...
Page 9
wARNING: RISk Of ChEmICAL buRN whAT CAN hAPPEN hOw TO PREVENT IT • Use of acids, toxic or corrosive • Do not spray ac i ds, gasoline, ker o s ene, chemicals, poisons, in s ec t i c ides, or or any other flammable materials with this any kind of flam m a b le solvent with this product. Use only household de t er g ents,...
Page 10
Spray wand: Allows the user to quickly change out high- pressure nozzles. See how To use Spray wand instructions in Operation section. Detergent Siphon hose (mSV2623) (not shown): Feeds cleaning agents into the pump to mix with the water. See how To Apply Chemicals/Cleaning Solvents instructions in Operation section.
Page 11
G. handle h. frame Pump Outlet Pump Inlet k. quick Connect Nozzles On board Detergent Tank (mSV3025): Feeds cleaning agents into the pump to mix with the water. See how To Apply Chemicals/Cleaning Solvents instructions in Operation section. BASIC ELEMENTS OF AN ENGINE Refer to the engine manual for location and operation of engine controls.
OpERATION pRESSURE WASHER TERMINOLOGY PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc. Sometimes noted as “Bar”, another unit of measure. GPm: Gallons per Minute. The unit of measure for the flow rate of water. Cu: Cleaning Units.
Page 13
Applying chemicals or cleaning solvents is a low pressure operation. NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach. To Apply chemicals (mSV2623): Press detergent siphon hose (F, Figure 7A) onto barbed fitting located near high pressure hose connection of pump as shown.
Page 14
After use of chemicals, place detergent siphon hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly. If chemicals remain in the pump it could be damaged. Pumps damaged due to chemicals will not be covered under warranty. NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed on the spray wand.
Page 15
• DO NOT use hot water, use cold water only. • Never turn water supply off while pressure washer engine is running or damage to pump will result. • DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged. If you do not understand these precautions, please contact our customer service department at www.simpsoncleaning.com! Prior to starting, refer to your engine manual for proper starting procedure. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating of 86 or higher.
WARNING: Risk of unsafe operation. stand on a stable surface and grip gun/spray wand firmly with both hands. Expect the gun to kick when triggered. 12. Release trigger to stop water flow. WARNING: Risk of injury from spray. Always engage the trigger lock (O) when gun is not in use.
Page 17
NOzzLE CLEANING (FIG. 12) If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions: Shut off the pressure washer and turn off the water supply.
NOTIcE: The use of any other accessory not recommended for use with this tool could be hazardous. Use only accessories rated equal to or greater than the rating of the pressure washer. SpECIFICATIONS mSV2623 mSV3025 Model PSI Max* 2600 psi...
TROUBLE SHOOTING GUIDE OPERATIONAL POSSIbLE CAuSE SOLUTION ISSuE Engine will not No fuel. Add Fuel. start (see Engine Pressure builds up after Squeeze gun trigger to relieve Manual for two pulls on the recoil pres sure. further engine starter or after initial use. troubleshooting) Choke lever in the "No Move choke to the "Choke"...
Page 21
OPERATIONAL POSSIbLE CAuSE SOLUTION ISSuE Will not draw Spray wand not in See how to use Spray wand paragraph in the chemicals low pressure. Operation Section. Chemical filter clogged. Clean filter. Chemical screen not in Make sure end of detergent cleaning solution.
Need help?
Do you have a question about the MSV2623 and is the answer not in the manual?
Questions and answers