Page 1
5,000W/240V WALL / CEILING MOUNTED GARAGE HEATER WITH ELECTRONIC CONTROLLER AND REMOTE OWNER’S MANUAL Model: PH-950NR IMPORTANT INSTRUCTIONS READ & SAVE PET OWNERS WARNING: The health of some small pets including birds are extremely sensitive to the fumes produced during the first-time use of many appliances. These fumes are not harmful to humans but we recommended that you do not use your heater around birds and small pets during its initial use until the manufacturing corrosion coatings burn off.
TABLE OF CONTENTS Important Instructions………………………………………. 3 Installing Instructions…………………………….………… 5-7 Specifications and Wiring Diagram ………………………. 8 Parts of the heater……………………….…………..……. Operating Instructions……………………….………..…… 10 Maintenance and Cleaning………………………………. Troubleshooting…………………………………………….
IMPORTANT INSTRUCTIONS PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER NOTE: There may be a trace of smoke or odor when unit is first operated. Don’t be alarmed. This indicates that a drop of oil fell on the heating coil during the manufacturing process. It will quickly evaporate and should not re-occur.
Page 4
Keep at least 4.5 inches (11.5 cm) from the back wall (with or without using the wall hanging mounting bracket). 9) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
Page 5
INSTALLATION INSTRUCTIONS WARNING: All wiring must be installed by a certified electrician according to the electrical safety. The ceiling heater must be grounded in accordance with all national and local building codes. WARNING: To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater.
Page 6
4. Mark the drill-hole positions in the wall or ceiling for the mounting bracket. 5. Drill the required holes with diameter fit for the anchor provided for positioning the mounting bracket. 6. Insert the anchors. 7. Attach the mounting bracket to the wall or ceiling and secure with mounting screws.
Page 7
10. Loosen the screw to remove the wiring compartment/connection cover in the rear of the heater. 11. Run the electrical power supply cable in flexible conduit and connect to the wiring compartment via the knock-out at back side of the unit. 12.
Page 8
SPECIFICATIONS 5,000W/240V WALL / CEILING MOUNTED GARAGE HEATER WITH ELECTRONIC CONTROLLER AND REMOTE Model: PH-950NR Volt: 240 V Watts: 5000 W Frequency: 60 Hz Recommended Heating Capacity: 1.25 watts / ft³ (0.03m³) Wiring diagram:...
PARTS OF THE HEATER A. Upper Enclosure G. Power LED B. Tilt adjustable knob H. Timer LED C. Front Exhaust Grill I. Low LED D. Louver for air direction J. High LED E. Control panel K. Inside/Wall Thermostat F. Alarm LED L.
OPERATING INSTRUCTIONS WARNING - The heater must be properly installed before it is used. HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH: Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70. A circuit breaker must be installed and serviced only by qualified electrical personnel.
Page 11
DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES! TURNING THE HEATER ON To turn the heater ON, press the ON/OFF rock switch to ON position, the power LED will turn on and display the room temperature.
To turn the timer OFF, press the TIMER button, and then pressing the “–” button to set the time to 0. The timer feature will turn off when the LED stops flashing To turn off the heater, switch off the circuit breaker. The circuit breaker serves as the power disconnection means.
There is no user maintenance part except regular cleaning as following description. All other servicing or maintenance should be performed by qualified service personnel. Before any cleaning, make sure that: 1. Disconnect power supply at source. Switch off the circuit breaker.
Page 14
If your heater fails to operate, please follow these procedures: This heater is intended to be a ceiling-mounted heater. It has a thermal cut-off protection. If the thermal cut-off protection trips, then, switch off the power. Switch off the circuit breaker.The unit should reset automatically after 10 minutes.
Page 15
WARRANTY INFORMATION This product carries a one (1) year warranty against defects in workmanship and materials. Profusion Heat agrees to replace a defective product, within the stated warranty period, when returned to the place of purchase with proof of purchase. This product is not...
Need help?
Do you have a question about the PH-950NR and is the answer not in the manual?
Questions and answers