Wash Cycles And Options; Table Of Wash Cycles; Wash Options - Indesit XWE 91483 Instructions For Use Manual

Wash cycles and options

Table of wash cycles

Description of the wash cycle
Special
1 Sport
2 Dark
3 Anti-odour (Cotton)
3 Anti-odour (Synthetic)
4 Delicate
5 Wool: for wool, cashmere, etc.
6 Duvet: for down-stuffed garments.
Standard
7 Cottons with Pre-wash: extremely soiled whites.
8 Eco Cotton 60°C (1): heavily soiled whites and resistant colours.
8 Eco Cotton 40°C (2): lightly soiled whites and delicate colours.
9 Cotton 40°C: lightly soiled whites and delicate colours.
Synthetic: heavily soiled resistant colours.
10
10 Synthetic (3): lightly soiled resistant colours.
11 Coloured
Eco & Rapid
Cotton 20°C: lightly soiled whites and delicate colours.
12
Eco Synthetic 20°C
13
14 Rapid
14 Rapid
Rapid
14
Partials
Rinse/Bleach
Spin + Drain
*
Drain only
*
If you select programme and exclude the spin cycle, the machine will drain only.
**
The duration of the wash cycle can be checked on the display.
The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary accor-
ding to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected.
1) Test wash cycle in compliance with regulation 1061/2010: set wash cycle 8 with a temperature of 60°C.
This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments
which can be washed at 60°C. The actual washing temperature may differ from the indicated value.
2) Test wash cycle in compliance with regulation 1061/2010: set wash cycle 8 with a temperature of 40°C.
This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments
which can be washed at 40°C. The actual washing temperature may differ from the indicated value.
For all Test Institutes:
2) Long wash cycle for cottons: set wash cycle 8 with a temperature of 40°C.
3) Synthetic program along: set wash cycle 10 with a temperature of 40°C.

Wash options

- If the selected option is not compatible with the set wash cycle, the
indicator light will flash and the option will not be activated.
- If the selected option is not compatible with another previously
selected option, the indicator light will flash accompanied by a buzzer
(3 beeps), and only the latter option will be activated; the indicator light
corresponding to the activated option will turn on.
Rapid
When this button is pressed the first time, the 9' icon will light
up, when pressed the second time the 30' icon lights up and
the third time the 1h icon lights up. When pressed the fourth
time the 9' icon lights up again.
Fast Forward
During a wash programme and under certain conditions,
pressing this button allows for ending the wash programme
after only 20' if necessary, by performing a brief rinse cycle
followed by a spin cycle at maximum 800 rpm or lower,
if reduced manually during the programme customisation
phase. In this case, washing and rinsing performance will be
reduced. After pressing the button, the relative indicator light
Detergents
Max. Max.
temp. speed
(°C) (rpm)
30° 600 -
 
30° 800 -  
60° 1000 -  
40° 1000 -  
30° 0 -
 
40° 800 -
 
30° 1000 -
 
90° 1400
  
60°
1400 -  
40° 1400 -
 
40°
1400 -
 
(Max. 90°)
60° 1000 -
 
40° 1000 -  
40° 1400 -  
20° 1400 -
 
20° 1000 -
 
- 800 - - 
30° 800 -
 
60° 1000 -
 
- 1400 - -

- 1400 - - -
- OFF - - -
turns on together with the indicator light of the rinse phase.
If the selected temperature is equal to 40° and/or the button
is pressed during the initial phase of the programme, the
"Fast Forward" option lasts longer so that the detergent can
dissolve properly and avoid damaging the fabrics. In this case,
the rinse phase indicator light flashes while the wash indicator
light remains fixed until the necessary activation conditions are
fulfilled. If less than 20' remain of the wash programme, the
option will be disabled.
Stain removal
This option allows for selecting the type of dirt so as to
optimally adjust the cycle for removing the stains. The
following types of dirt can be selected:
- Food, for stains caused by foodstuffs and beverages,
for example.
- Work, for grease and ink stains, for example.
Outdoor, for mud and grass stains, for example.
-
! The wash cycle duration varies according to the type of
selected dirt.
**
- 5 - - -
**
- 5 - - -
**
- 3,5 - - -
**
- 3,5 - - -
**
- 1 - - -
**
- 2 - - -
**
- 3,5 - - -
**
- 9 - - -
- 9 53 1,19 57,5 195'
- 9 53 1,09 92 175'
**
- 9 - - -
- 4,5 46 1,10 55 120'
**
- 4,5 - - -
**
- 9 - - -
**
- 9 - - -
**
- 9 - - -
- 1,5 - - - 9'
- 3,5 80 0,19 46 30'
- 9 - - - 60'
**
9 - - -

**
- 9 - - -
**
- 9 - - -
23
GB