Advertisement
3.2.3 DISASSEMBLY of [13] MONITOR ASSEMBLY
CAUTIONS
(1) Remove the MONITOR ASSEMBLY from the UPPER
CASE ASSEMBLY first, as they are removed together in
main parts disassembly, and then proceed to the disas-
sembly procedure.
(2) During the procedure, be careful in handling the LCD
MODULE and other parts. Pay special attention not to
damage or soil the monitor screen. If fingerprints are left
on the screen, wipe them with clean chamois leather or
a cleaning cloth.
Removing MONITOR ASSEMBLY
(1) Remove the two screws (1 and 2), and remove the MON-
ITOR ASSEMBLY.
NOTE13a:
During the procedure, be careful not to damage the
parts, or cut/ break the WIRE.
Disassembly of MONITOR ASSEMBLY
(1) Remove the five SCREWS (3-7), and remove the MON-
ITOR COVER.
7
(S13b)
6
(S13b)
5
(S13b)
4
(S13b)
NOTE13b,c,d
LCD MODULE
MONITOR CASE
L13a
(S13c)
8
(S13c)
MONITOR COVER
3
(S13b)
BKT(MONI.PWB)
HINGE UNIT ASSY
LCD SUB BOARD ASSY
CN13a
b
a
b
CN13b
a
L13b
9
(2) Remove the CONNECTOR CN13a.
(3) Peel off the SPACERS, and remove the BRACKETS
(MONI.PWB).
(4) Remove the CONNECTOR CN13b, and remove the
LCD MODULE and the LCD-SUB BOARD ASSEMBLY.
NOTE13b:
The LCD MODULE is single-construction with built-in
BACK LIGHT. Neither the LCD MODULE nor the
BACK LIGHT can be replaced as a single part.
NOTE13c:
Since the LCD MODULE is soldered to the LCD-SUB
BOARD ASSEMBLY (SD13), they should be removed
together except for replacement.
NOTE13d:
During the procedure, be careful not to damage the
parts, or cut/ break the WIRE.
(5) Remove the two SCREWS (8 and 9), and remove the
HINGE UNIT ASSEMBLY.
LCD MODULE
E-PRIMARY WIRE
B.LIGHT(-)
(BLACK)
Fig.3-2-3
E-PRIMARY WIRE
B.LIGHT(+)
(RED)
CN13a
BKT(MONI.PWB)
SD13
SPACER
UPPER CASE
ASSY
NOTE13a
1
(S13a)
2
(S13a)
(No.YF058)1-25
Advertisement
