Advertisement
(5) Press the Media Recognition button (shown above) to rec-
ognize the medium.
Click to take off the check
at the next of SCSI
(6) It will take about 20 - 30 seconds to recognize the medium.
NOTE:
Detected and displayed here is the name of Microdrive.
When the recognition is completed
normally, the detected medium is displayed.
(7) Click the recognized media display (Model name) to the
select status (Highlighted) and press go button.
Click the selected media
(8) The Window is open to start the checking.
To finish during the procedure, press abort button.
(9) When
"Drive
Explorer
displayed here, the checking is finished.
At the same time Print, View, Exit buttons are displayed.
1-16 (No.YF058)
Press the Media
Recognition button
(shown above) to
recognize the medium.
Press go button
completed
successfully."
When "Drive Explorer completed
successfully." is displayed here,
the checking is finished.
NOTE:
Although the usual checking time is about 15-20 min-
utes, it varies depending on the each PC's performance.
If it takes too long (more than 30 minutes), there may be
a failure in checking. Finish the checking by pressing
Abort button and start the checking again.
(10) Press either Print button or View button to print or display
the checking result.
When confirming the checking is finished, press Exit
button.
Print button
(11) The checking result will be output if the Print button is
pressed.
The checking result will be displayed if the View button is
pressed.
Pressing the Print button located in the bottom right can do
the printing.
When the confirmation is done, press Exit button to finish
the result display.
is
(12) Press either X button or Exit in the File menu to finish the
program.
Exit button
Print button
Exit button
Press X button
Advertisement
