Makita PK5011C Instruction Manual
Hide thumbs Also See for PK5011C:


Quick Links

Angle Sander
IMPORTANT: Read Before Using.


Table of Contents

Summary of Contents for Makita PK5011C

  • Page 1 INSTRUCTION MANUAL Angle Sander PK5011C 012054 IMPORTANT: Read Before Using.
  • Page 2: Specifications

    ENGLISH (Original instructions) SPECIFICATIONS Model PK5011C Spindle thread Abrasive disc / Offset diamond wheel 125 mm Rated speed (n) / No load speed (n 2,000 - 5,500 min Overall length 468 mm Net weight 3.8 kg • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
  • Page 3 moving parts. Damaged or entangled cords Power tool use and care increase the risk of electric shock. 18. Do not force the power tool. Use the correct When operating a power tool outdoors, use an power tool for your application. The correct extension cord suitable for outdoor use.
  • Page 4 GEB089-3 be capable of stopping flying debris generated by various operations . The dust mask or respirator WET SANDER SAFETY must be capable of filtrating particles generated by WARNINGS your operation. Prolonged exposure to high intensity noise may cause hearing loss. Safety Warnings Common for Grinding or Sanding Keep bystanders a safe distance away from Operation:...
  • Page 5 a) Maintain a firm grip on the power tool and 24. When using the water feed, be careful not to position your body and arm to allow you to let water get into the motor. If water runs into resist kickback forces. Always use auxiliary the motor, an electric shock hazard may result.
  • Page 6: Functional Description

    Switch action FUNCTIONAL DESCRIPTION 1. Lock button CAUTION: 2. Switch trigger Always be sure that the tool is switched off and • unplugged before adjusting or checking function on the tool. Ground Fault Circuit Interrupter 1. Pilot lamp 2. RESET (R) 012041 button CAUTION:...
  • Page 7 CAUTION: The speed adjusting dial can be turned only as far • as 6 and back to 1. Do not force it past 6 or 1, or the speed adjusting function may no longer work. If the tool is operated continuously at low speeds, •...
  • Page 8 To remove the dust cover, follow the installation Installing or removing offset-diamond-wheel procedure in reverse. cover (Optional accessory) Installing or removing abrasive disc (Optional 1. Offset-diamond-wheel accessory) cover 2. Screws NOTE: 3. Set band Use sander accessories specified in this manual. •...
  • Page 9: Operation

    Hold the tool firmly. Turn the tool on and then apply the When you find buildup of dust in that area, ask Makita abrasive disc to the workpiece. service center for cleaning inside of the tool. Never...
  • Page 10: Optional Accessories

    Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Abrasive discs (wet type) • 001146 Side grip When the resin insulating tip inside the carbon brush is •...
  • Page 12 Makita Corporation 885035A0...

Table of Contents