Table of Contents
Advertisement
In case the holes don't match with the lock nut
wrench
012038
Remove the front-edge cover by sliding it. Then press the
shaft lock and hold the two parallel flats of the offset
diamond wheel by a wrench and turn it. If you can't see
the parallel flats, press down the offset-diamond-wheel
cover with your fingers.
OPERATION
Sanding operation
WARNING:
To reduce the risk of electric shock, check the
•
tool's water supply system to ensure there is
no damage to the seals ("O" rings) or hoses. A
damaged water supply system may result in
abnormal water flow to the tool which could be
dangerous.
When you connect a vacuum cleaner to the
•
offset-diamond-wheel cover, always use a wet
type. Using a dry type vacuum cleaner to collect
wet dust could result in electric shock, fire and/or
property damage.
CAUTION:
Always wear safety goggles or a face shield during
•
operation.
Never switch on the tool when it is in contact with
•
the workpiece, it may cause an injury to operator.
Always use the abrasive disc together with the
•
rubber pad. Using the rubber pad by itself may
seriously damage the rubber pad.
When using the abrasive disc, make sure that the
•
dust cover is attached on the tool. Otherwise water
and dust come into the tool and it can cause tool
failure.
When using the offset diamond wheel, install the
•
offset-diamond-wheel cover. Contact with a rotating
wheel can result in serious injury.
Make sure that the cock is closed. Connect the hose to
the tool. Make sure that water comes out when the water
lever is opened.
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
012034
When using an abrasive disc, keep the abrasive disc at
an angle of about 15 ﾟ to the workpiece surface.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to abrasive
disc.
When using an offset diamond wheel, apply the offset
diamond wheel flat on the work surface.
NOTE:
The dust collection with a vacuum cleaner is
•
effective only when grinding a flat surface.
Planing in corners
Flush planing of corners is possible after first removing
the dust cover cap.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
2
012047
The tool and its air vents have to be kept clean. Regularly
clean the tool's air vents or whenever the vents start to
become obstructed.
Long use and operation of the tool using much water
causes buildup of dust inside the tool. To maintain the
product safety and operate the tool with high efficiency,
always check the exhaust vent at the back of tool.
When you find buildup of dust in that area, ask Makita
service center for cleaning inside of the tool. Never
9
1. Exhaust vent
2. Inhalation vent
1
Advertisement
Table of Contents
