Mitsubishi Electric PAR-32MAAG Instruction Book page 9

1Operation mode
Indoor unit operation mode appears here.
2Preset temperature
Preset temperature appears here.
3Clock
(See the Installation Manual.)
Current time appears here.
4Fan speed
Fan speed setting appears here.
5Button function guide
Functions of the corresponding buttons appear
here.
6
Appears when the ON/OFF operation is centrally
controlled.
7
Appears when the operation mode is centrally
controlled.
8
Appears when the preset temperature is centrally
controlled.
9
Appears when the filter reset function is centrally
controlled.
0
Indicates when filter needs maintenance.
aRoom temperature
(See the Installation Manual.)
Current room temperature appears here.
b
Appears when the buttons are locked.
Most settings (except ON/OFF, mode, fan speed, temperature) can be made from the Menu
screen. (Refer to page 20.)
Page 14
c
Appears when the On/Off timer (Page 26),
Night setback (Page 43), or Auto-off timer
Page 15
(Page 28) function is enabled.
centralized control system.
d
Appears when the Weekly timer is enabled.
Page 16
e
Appears while the units are operated in the
energy-save mode. (Will not appear on some
models of indoor units)
f
Appears while the outdoor units are operated in
the silent mode.
g
Appears when the built-in thermistor on the
remote controller is activated to monitor the
room temperature (a).
indoor unit is activated to monitor the room
temperature.
h
Indicates the vane setting.
i
Indicates the louver setting.
Page 54
j
Indicates the ventilation setting.
k
Appears when the preset temperature range is
restricted.
l
Page 36
Appears when an energy-saving operation is
performed using a "3D i-See sensor" function.
Page 26, 28, 43
appears when the timer is disabled by the
appears when the thermistor on the
Page 30
Page 41
Page 32
Page 22
Page 23
Page 23
Page 34
9