TOTALINE P374-1 900 Installation Instructions Manual page 9

Explanation of Jumper Settings Explanation of Jumper Settings
W3 JUMPER SETTING
3
If the jumper for MISC1, MISC2, or MISC3 is set to W3, the corresponding MISC
screw terminal on the backplate will control a third stage of heat.
W3 MULTI-STAGE OPERATION EXPLAINED - SECTION 14 of the Owner's
The 3rd Stage of Heat is turned on when:
(A) The 1st and 2nd stages have been on for the time required (steps 27
and 28, page 14.6). It is adjustable from 0-60 minutes and the default
And
is two minutes.
(B) The temperature from the setpoint is equal to or greater than: the set-
point plus the 1st stage deadband (step #24, 14.5), plus the 2nd stage
deadband (step #25, 14.5) plus the 3rd stage deadband (step #26,
14.5). This 3rd stage deadband is adjustable from 0-10 degrees and
the default is two degrees.
Heating
Deadband Deadband
db 3 db 2
(adj. 0-10 ) (adj. 0-10 )
3rd Stage 2nd Stage 1st Stage
turn on turn on turn on
DECREASE
PROG JUMPER SETTING
If the jumper for MISC1, MISC2, or MISC3 is set to PROG, the corresponding MISC screw
terminal on the backplate will control a pilot relay or other accessory.
PROGRAMMABLE OUTPUT - SECTION 15 of the Owner's Manual
This jumper setting allows the MISC outputs to control a pilot relay by time,
temperature, or a signal from the Internet/Phone. The following are three
possible scenarios:
By Time: A device that requires a start and stop time. An example
of this would be an exterior lighting system that needed to be
energized every day between the hours of 8pm and 1am.
By Temperature: An exhaust fan that needs to energize whenever
the temperature from RS2 rises above 90 degrees F.
By Remote: Remotely arming a security system through the web or phone.
Manual
Cooling
Deadband Deadband Deadband
db 1 db 1 db 2
(adj. 1-6 ) (adj. 1-6 ) (adj. 0-10 )
Heat Cool 1st Stage
Setpoint Setpoint turn on
TEMPERATURE INCREASE
Page 3.3
TOTALINE
2nd Stage
turn on