Sharp AQUOS LC-70UHD80R Operation Manual page 60

Connecting a PC
Adjusting the PC image
automatically
Option
Auto sync.
This function enables the screen to be automatically
adjusted to its best possible condition when the
analogue terminals of the TV and PC are connected
with a commercially available DVI/RGB conversion
cable, etc.
1 Press b to select "PC" from the "INPUT"
menu, and then press ;.
2
Go to TV Menu" > "Setup" > "Option" >
"Terminal setting" > "PC signal setting" > "Auto
sync.".
NOTE
• When "Auto sync." is successful, "Auto Sync completed
successfully" displays. If not, "Auto sync." failed.
• "Auto sync." may fail even if "Auto Sync completed
successfully" displays.
• "Auto sync." may fail if the PC image has low resolution,
has unclear (black) edges, or is moved while executing
"Auto sync.".
• Be sure to connect the PC to the TV and switch it on
before starting "Auto sync.".
• "Auto sync." can be executed only when inputting
analogue signals through the PC terminal.
• This function is available for 3D images converted from
2D images or normal 2D images.
Adjusting the PC image manually
Option
Fine sync.
Ordinarily you can easily adjust the picture as
necessary to change image position using "Auto
sync.". In some cases, however, manual adjustment
is needed to optimise the image.
1 Press b to select "PC" from the "INPUT"
menu, and then press ;.
2
Go to "TV Menu" > "Setup" > "Option" >
"Terminal setting" > "PC signal setting" > "Fine
sync.".
3 Press a/b to select the specific adjustment
item.
4 Press c/d to adjust the item to the desired
position.
Item
Centres the image by moving it to the
H-Pos.
left or right.
Centres the image by moving it up or
V-Pos.
down.
Adjusts when the image flickers with
Clock
vertical stripes.
Adjusts when characters have low
Phase
contrast or when the image flickers.
NOTE
• For resetting all adjustment items to the factory preset
values, press a/b to select "Reset", and then press
;.
• "Clock" and "Phase" in the "Fine sync." menu can be
adjusted only when inputting analogue signals through
the PC terminal.
• This function is available for 3D images converted from
2D images or normal 2D images.
58