Table of Contents
Advertisement
To remove the ear hook from the headset:
.
Hold the headset with one hand and the ear hook with your
other hand.
.
Pull the end of the ear hook up until it separates from the
rotating clip on the headset.
Headband
To attach the head band to the headset:
.
Remove any headset attachment
connected to the headset.
3.
To wear the headset on your right ear,
insert the end [A] of the head band into
the rotating clip [B] on the headset until
it clicks into place.
•
To wear on your left ear, hold the headset with one hand and the head band with
your other hand. Rotate the head band within the rotating clip on the headset.
To remove the head band from the headset:
.
Hold the headset with one hand and the head band with
your other hand.
.
Pull the end of the head band until it separates from the
rotating clip on the headset.
Bluetooth
To use a Bluetooth enabled cell phone with your
DS6670, you must first pair and connect your
Bluetooth cell phone(s) with the telephone base.
All DS6670 handsets can be used to make or answer
calls on the cell lines.
Bluetooth wireless technology operates within a short
range (a maximum of approximately 30 feet). When
you pair a Bluetooth cell phone to the telephone
base, place your Bluetooth cell phone closer to the
telephone base to maintain sufficient signal strength.
For optimal performance, keep your cell phone within
5 feet of the telephone base while using the cell line.
Pair and connect your first Bluetooth cell phone
.
Press and hold
seconds. You hear a tone and the
.
Turn on the Bluetooth feature of your cell phone. Once your cell phone finds
your VTech phone (VTech DS6670), press the appropriate key on your cell
phone to continue the pairing process.
•
Your cell phone may prompt you to enter the PIN of the telephone base.
The default PIN of the telephone base is 0000.
VTech Connect to Cell
This application helps you integrate your Android phones with
your DS6670. For more information and application download,
go to http://www.vtechphones.com/app_connect_to_cell
CELL 1/ CELL 2 on the telephone base for about four
application
TM
.
Attach the ear pad to the headset
earpiece.
4.
Adjust the head band to fit your
head. Adjust and rotate the angle of
the headset until the microphone is
pointing towards your mouth. Firmly
grip the earpiece with one hand
whenever adjusting the headset
microphone up or down.
CELL 1/ CELL 2 light blinks.
Advertisement
Table of Contents
