Table of Contents
Advertisement
Linksys
Click Next when the New Scope Wizard Begins
3
4
Enter the name and description for the scope, click Next
5
Define the IP address range Change the subnet mask if necessary Click Next
Figure 50: IP Address Screen
6
Add exclusions in the address fields if required If no exclusions are required,
leave it blank Click Next
Change the Lease Duration time if preferred Click Next
7
8
Select Yes, I want to configure these options now, and click Next
9
Enter the router address for the current subnet The router address may be
left blank if there is no router Click Next
Appendix C PC And Server Configuration
10 For the parent domain, enter the domain you specified for the domain
controller setup, and enter the server's address for the IP address
Click Next
Figure 51: DNS Screen
11 If you don't want a WINS server, just click Next
12 Select Yes, I want to activate this scope now Click Next, then Finish
13 Right-click on the server, and select Authorize It may take a few minutes
to complete
43
Advertisement
Table of Contents
