Advanced Settings - Linksys LAPAC1750 User Manual

Linksys
Data - Workgroup Bridge Screen
Workgroup Bridge
Radio
Select the desired radio from the list
Workgroup Bridge Status
Status
Enable or disable Workgroup Bridge function
Workgroup Bridge can only be enabled when
VLAN function is disabled
Before configuring Workgroup Bridge, make
sure all devices in Workgroup Bridge have the
following identical settings
Radio
IEEE 802 11 Mode
Channel Bandwidth
Channel (Auto is not recommended)
Infrastructure Client Interface
SSID
Enter the name of the SSID to which
Workgroup Bridge will connect or click Site
Survey button to choose from the list You
must do this for Workgroup Bridge to connect
to a remote access point
Remote MAC Address
Normally, Workgroup Bridge connects to
a remote access point by matching SSID
When multiple remote access points has the
same SSID,Workgroup Bridge can connect to
different remote access points
Optional: You can specify the MAC address of
the remote access point to limit Workgroup
Bridge's connection to a specific remote
access point The format is xx:xx:xx:xx:xx:xx
Security Mode
Select the desired mode from the list
Disabled
WPA-Personal
WPA2-Personal

Advanced Settings

Configure advanced parameters of the wireless radios
Figure 31: Advanced Settings
CHAPTER 2 Access Point Setup
24