Panasonic Lumix DMC-FX3PP Service Manual page 34

Service Manual
Diagrams and Replacement
Parts List
Digital Camera
DMC-FX3PP DMC-FX3EGM
DMC-FX3PL DMC-FX3GC
DMC-FX3EB DMC-FX3GD
DMC-FX3EE DMC-FX3GK
DMC-FX3EF DMC-FX3GN
DMC-FX3EG DMC-FX3GT
Vol. 1
Colour
(S)...........Silver Type
(K)...........Black Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Flash Top P.C.B. .................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Flash Top Schematic Diagram .............................................. S-5
S4.3. AF Assist LED Schematic Diagram ....................................... S-6
S4.4. CCD Flex Schematic Diagram .............................................. S-6
S4.5. Lens Flex Schematic Diagram .............................................. S-7
S5. Print Circuit Board .................................................................... S-8
S5.1. Flash Top P.C.B. .................................................................... S-8
S5.2. AF Assist LED P.C.B. ............................................................ S-9
S5.3. CCD Flex P.C.B. .................................................................... S-9
S5.4. Lens Flex P.C.B. .................................................................. S-10
DSC0608023CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S6. Replacement Parts List .......................................................... S-11
S7. Exploded View ....................................................................... S-18
S7.1. Frame and Casing Section.................................................. S-18
S7.2. Packing Parts and Accessories Section (1) ........................ S-19
S7.3. Packing Parts and Accessories Section (2) ........................ S-20
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.
Name of Signal
S-1
HAVE THE SPECIAL CHARACTERISTICS