Sagem My-X2a Manual page 70

251312906 My-X2a English.book Page 70 Mercredi, 9. juillet 2003 1:46 13
Troubleshooting
P - S
ROBLEM ITUATION
No call connection
No call reception
Network reception less good
during a call
Impossible to send message
No answer phonebox
Answer phone icon flashing
Backlight does not work
In WAP context:
SERVER NOT ANSWERING
message
Logon to home page impossible
Operator name does not appear on
screen
How do I (un)lock the keypad?
70
ACTIONS
Check the called number. Check that at least one signal strength bar is
present. If the R icon appears without any operator name being displayed,
only emergency calls are possible.
Check that your call credit with your operator has not been used up.
Check that the SIM card used offers the service that you are requesting and
that its validity has not expired.
Check and deactivate the restriction on outgoing calls if necessary.
The network is overloaded. Call again later.
If the poor call connection persists, contact the hotline.
Try to make a call to check that the phone and the network are operational.
Check and deactivate the permanent calls forwarded (permanent calls
forwarded icon displayed). Check and deactivate the restriction on incoming
calls if necessary. If the poor reception persists, contact the hotline.
Avoid holding the phone with your fingers at the top of the rear cover; this
creates an obstacle for the antenna located at this spot.
Check that the SIM card used offers this service. Try to make a call to check
that phone and network are operational.
Check the answer phone number is properly configured. To do this, go to the
"Calls" menu, select "Answer phone number" and check the number.
Otherwise, enter your operator's answer phone centre number.
Check that the SIM card does offer this service.
Programme the call to be forwarded to answer phoneusing the information
provided by the operator.
Call the answer phone to make it disappear.
Go into the Settings menu, select the Energy saving menu and activate
backlight
Switch off and then switch phone back on.
In the WAP menu, Clear the cache.
Go into the Settings menu, select Networks, then Selection. Wait until the
operator appears, select it and accept.
Hit key, then the right programmable key (OK).