Before Starting Playback; Loading The Batteries In The Remote Control; Connecting The Power Cord - Sharp BD-HP20H Operation Manual

Before Starting Playback

Loading the Batteries in the Remote
Control
1
Press down on the tab in the direction of the
arrow to remove the battery cover.
2
Load the two R-03 size batteries ("AAA" size,
UM/SUM-4) supplied with the remote control
unit. Make sure that the battery poles m and n
are positioned as indicated.
3
Slide the battery cover in the direction of the
arrow until it clicks.
NOTE
• Do not subject the remote control unit to shock, water or
excessive humidity.
• The remote control unit may not function if the Player's remote
sensor is in direct sunlight or any other strong light.
• Incorrect use of batteries may cause them to leak or burst. Read
the battery warnings and use the batteries properly.
• Do not mix old and new batteries, or mix different brands.
• Remove the batteries if you will not use the remote control unit for
an extended period of time.
Approximate operating range of remote
control
Remote control sensor
30º 30º
7 m

Connecting the Power Cord

Plug the supplied AC cord into the AC IN terminal on the rear
of the Player. Then plug into AC outlet.
NOTE
• Place the Player close to the AC outlet, and keep the power plug
within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE
UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD
IS CONNECTED.
• The a (STANDBY) indicator blinks while the Player is preparing for
starting up. You cannot turn the Player on until the a (STANDBY)
indicator stops blinking.
Remote control unit
To AC IN terminal
To AC outlet
21