Advertisement
GC982NW1F.BHKGLLS_ENG
3/20/09
Tuning
and adjusting TV stations manually
You may prefer to tune your television manually. Manual tuning can be more effective if the television signal in your area is too
weak for the ACMS to work properly. You can also fine tune your channels and customise the channel names.
6
Manual tuning
1 Turn on your television and your
Video. Select the video channel on
your television and press
to
access the main menu.
2 Press either 1 or 2 to select PR
SET then press OK.
3 Press
again and the television
station table will then appear.
4 Use the 3 or 4 buttons to select
the programme number you want
to tune then press OK.
5 GC470W Only : Press OK again
and use 3 or 4 to select a
desired TV system according to
the area you live in (I/I, B/G, D/K).
PR
CH
MFT
STATION
06
C- -
- -
- - - - -
I/I
B/G
D/K
P SET
OK
i
R
6 GC470W Only : Press OK.
7 Select the CH section (if not
already selected) by using the 1
or 2 buttons and then press AV
to select C (Standard stations) or
S (Cable stations).
4:46 PM
Page 6
8 Use the 3 or 4 buttons to move
through the channel numbers to
find the required station.
9 The station can be fine tuned to
improve picture quality. Select
MFT (Manual Fine Tuning) using
the 1 or 2 buttons. Use
the 3 or 4 buttons to adjust the
picture.
10 Select STATION by pressing 2 you
can then name your station.
11 Press OK.
PR
CH
MFT
STATION
06
C40
00
-
P SET
OK
i
R
12 Use the 3 or 4 to select letters
and numbers for the new station
name up to a maximum of 5.
13 Press 1 or 2 to move between
the characters.
14 Press OK.
15 To confirm the station placement
press
.
16 Press
again to remove the
menu.
17 The new station has now been
stored into your Video.
If you wish to manually tune other
channels you should repeat the
above procedure.
To move the manually tuned channel
to it's correct position see Changing
the order of the television stations
on page 5.
If it is necessary for you to tune all
the television stations manually you
may find it easier if you write the CH
numbers down for each station as
you find them. You can then select
each channel from the main menu
and type the CH numbers in directly.
Each channel will then be in the
correct position so there is no need
to change them later.
Advertisement
