Watchguard XTM 25 Hardware Manual page 5

Front View
The front panel of the device.
Fail Over
The Fail Over indicator is lit when there is a WAN failover from the primary external interface to the
backup interface. After the external interface connection fails back to the primary external interface,
the indicator is not lit.
WAP
The WAP indicator is lit when the XTM 2 Series wireless device is activated as a wireless access point
or as a wireless client.
Network interface status indicators
The five network interfaces are labeled 4, 3, 2, 1, 0. There are two status indicators for each interface.
Indicator
1000
10/100
Status
The Status indicator shows when there is a management connection to the device. The Status
indicator is lit for 30 seconds after you connect to the device with the Fireware XTM Web UI or the
command line interface. It is also lit when the device is polled by WatchGuard System Manager.
Mode
The Mode indicator shows the status of the external network connection. If the device can connect
to the external network and send traffic, the indicator is green. The indicator flashes if the device
cannot connect to the external network and send traffic.
Attn
The Attn indicator is lit when you start the device with the Reset button pressed. For more
information, see "The lithium battery used in the security appliance may not be replaced by the user.
Return the appliance to a WatchGuard authorized service center for replacement with the same or
equivalent type recommended by the manufacturer. If, for any reason, the battery or security
appliance must be disposed of, do so following the battery manufacturer's instructions." on page 6
Power ( )
The power indicator is lit when the device is on.
Hardware Guide
Indicator color
Yellow
Blinks (speed of blink increases as
the data flow increases)
Green
Blinks (speed of blink increases as
the data flow increases)
Hardware Specifications
Interface Status
Link speed: 1000 Mbps
Data sent and received
Link speed: 10 Mbps or 100 Mbps
Data sent and received
3