Table of Contents
Advertisement
Part Names and Functions
Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5
m) and 60 degrees in front of the projector.
The different remote control codes (Code 1–Code
) are assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment next
to each other are operated at the same time. Change the
remote control code for the projector first before changing
that for the remote control. See "Remote control" in the
Setting Menu on page 5.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and
Code 2. The initial code is set to Code 1.
1
Remote Control Battery Installation
Install new batteries
2
into the compartment.
Remote Control Operating Range
Remote Control Code
Two AAA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in compartment.
Replace the
3
compartment lid.
16.4'
(5 m)
30°
30° Remote control
MENU button
IMAGE button
Advertisement
Table of Contents
