76 Firmware Update
10.2 From the network via LAN port
10.2.1 Automatic firmware update via LAN port
NOTE
You can only update with firmwares of which system identifi-
cation is identical to that of yours. Otherwise you will fail in
firmware update.
You can get a new firmware from the network via LAN port.
If you have a static IP address, set the DHCP option to Off, then
the IP Address, Subnet Mask and Gateway options become
enabled. You have to set these options according to your IP
address.
To update the firmware automatically, follow the steps below:
1. Plug a LAN calbe into the LAN port on the digital receiver.
2. Select the Installation
3. Set the Auto LAN Firmware Upgrade option to On, then turn
off the digital receiver.
Select the Installation
ting
IP Configuration menu.
You should see a screen like the
left figure.
You may assign a dynamic IP ad-
dress to the digital receiver. To
do so, set the DHCP option to
On.
LAN Setting menu.
LAN Set-