Homelink ® With Auto-Dimming Rearview Mirror - Kia SPORTAGE Features & Functions Manual

OTHER KEY FEATURES
HomeLink with Auto-Dimming Rearview Mirror*
®
Designed to help reduce glare from a vehicle's headlights located in the rear and also connect up to three electronic transmitters
in one location. Press the on/off button
REMINDER:
Mirror indicator light will illuminate when automatic dimming is ON.
How to Sync Transmitter
1. Press and release , or
A B D
– If the indicator flashes slowly in red, go to Step 3
C
(Programming)
– If the indicator is continuously turned ON or flashes
C
rapidly in red several times, go to Step 2 (Erasing)
2. Press and hold the button you wish to erase the program
for approximately 15-25 seconds until the LED flashes
slowly in Red
3. Hold the Garage Door Opener Original Transmitter near the
HomeLink Mirror
4. Press and hold the desired button (
Original Transmitter button until the indicator
on continuously or flashes rapidly in red. This indicates the
programming is completed
To complete programming of a Rolling Code garage door opener:
1. Firmly press and release the "Learn," "Smart," or "Program"
button of the garage door opener while the indicator
slowly in red. Once the button is pressed, you have approximately
30 seconds to initiate the next step
2. Return to the vehicle and firmly press and hold the HomeLink
button for two seconds and release. Repeat this up to three
times to complete the programming. Do not press the HomeLink
button rapidly. At this point, programming is complete and your
device should operate
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
to turn the auto-dimming function on or off.
F
button:
A
B
C
D
A , B or D ) and the
is turned
C
C flashes
†12
C E
A B D
HomeLink button E Glare detection sensor
®
HomeLink button F Automatic dimming ON
®
Indicator light G Automatic dimming OFF
HomeLink button
®
QUICK TIP
If the indicator flashes rapidly in red continuously, but if
C
the garage door opener does not operate, please continue
to follow Rolling Code Programming steps below
Operating HomeLink : Press one of the programmed HomeLink
®
Erasing programmed buttons: Press and hold the left
simultaneously for approximately 20 seconds, until the indicator light begins to
flash, and then release both buttons within 30 seconds.
QUICK TIP
Erasing programmed buttons will delete all trained transmitters
REMINDERS:
•
A ladder may be needed to access the garage door opener
•
A second person may be needed to help
•
Some of the steps are time sensitive
*IF EQUIPPED
QR CODE
Homelink Support Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website.
Refer to inside front cover
for more information.
F G
www.youtube.com/KiaFeatureVideos
®
and center
A
For more information, go to HomeLink.com
or call (800) 355-3515.
See section 4 in the Owner's Manual for
more information.
†LEGAL DISCLAIMERS ON BACK INSIDE COVER
buttons.
buttons
D
43