About This Manual; Symbols Glossary; Safe Use; Introduction - Bartington Mag-03 Operation Manual

Three-axis magnetic field sensors

Table of Contents

1. About this Manual

This manual describes the installation, operation and maintenance of the Mag-03 range of three

axis magnetic field sensors. It should be read in conjunction with the product brochure (DS0013)

which can be found on the product page of the Bartington Instruments at: www.bartington.com.

Details of the enclosures, mounting, connector dimensions, connector pin allocation and the

position of the sensing elements relative to the enclosure are given in outline drawings on the

product page.

See Application Note AN0045: 'Magnetic Units and Measurements', available from Bartington

Instruments, for important information about magnetic field measurement units.

The following symbols used within this manual call your attention to specific types of information:

WARNING: Indicates a situation in which serious bodily injury or death could result if the

warning is ignored.

Caution: Indicates a situation in which bodily injury or damage to your instrument, or both,

could result if the caution is ignored.

Identifies items that must be disposed of safely to prevent unnecessary damage to the

environment.

Note: Provides useful supporting information on how to make better use of your purchase.

WARNING: These products are not qualified for use in explosive atmospheres or life support

systems. Consult Bartington Instruments for advice.

These compact, high performance sensors with integral electronics provide measurements

of static and alternating magnetic fields in three axes. The sensors, also described as

magnetometers, convert magnetic flux density, measured in three axes, into a bipolar analogue

voltage. Analogue output voltages Vx, Vy and Vz vary linearly with magnetic flux density.

The analogue output is positive for conventional flux direction, South to North, in the direction

of the arrow shown on the label for each axis; i.e. the maximum positive output will be obtained

from any axis when the arrow points towards magnetic north along the total field vector. The

BARTINGTON INSTRUMENTS

Page 4 of 14

OM1004/29

Table of Contents